Release film manufacturers explain how to stick the cell phone film

Whenever a new machine is in the hands of people add a piece of protective film to its screen, but how to paste the cell phone film is good? Generally, the paste of the protective film will be sold by the film businessmen on behalf of the work. However, once you find the protective film paste crooked, or with the old need to replace the time, and then have to run to find merchants again on behalf of the work, quite a hassle. The film is not a “difficult operation”, as long as the selection of high-quality protective film products, and a clear understanding of the process of film, do-it-yourself film is not difficult. The following release film manufacturer Dingli editor will explain the cell phone film tutorial.

Steps/methods:

Step 1: Clean the screen.

For cell phone film how to paste the problem, the use of a BG wipe (or fiber soft cloth, glasses cloth can also) to wipe the screen, and the phone screen thoroughly clean. Wipe the screen in the best indoor windless, clean environment to reduce the impact of dust on the film, because the film before a thorough cleaning is a must this must be known, such as inadvertently stained with dust will have a direct impact on the results of the film, light leads to film bubbles, heavy leads to film failure. The poor quality protective film is because the film process into the dust can not be cleaned up, directly destroying the protective film of the silicone layer, making the film scrap can not be used.

Use BG dust removal stickers to clean up stubborn dirt, after cleaning with a cloth, if the screen is still stubborn dirt, do not use a wet cloth to clean this point is very important. Just stick the BG Dust Remover Sticker on the dust, then lift it and use the adhesive force of the Dust Remover Sticker to clean off the dust. The BG Dust Remover Sticker can be used repeatedly by sticking it back to the original backing paper after use.

Step 2: Get the initial impression of the sticker.

Questions about how to apply a cell phone film will be answered in detail in the following cell phone film tutorial. The protective film from the package inside out, do not tear the release film, directly to the phone screen, to get a preliminary impression of the film, especially to observe the film edges and the phone screen fit, the location of the film to have a general understanding of the film, which will help the back side of the film program.

Step 3: Tear off part of the ① release film.

Observe the label on the protective film, tear off a part of the release film labeled “①”, and pay attention to avoid touching the adsorption layer of the protective film with your fingers. Each piece of protective film is divided into three layers, of which ① and ② are release films to protect the middle protective film.

Step 4: Paste the film onto the phone screen slowly.

Align the adsorption layer of the protective film with the corners of the screen, make sure the position is aligned, and then stick it on carefully. Tear off the ① release film while pasting, if the film process produces air bubbles, you can pull back the film and re-paste it. After confirming that the position of the film is completely correct, then completely peel off the ① release film. After the whole protective film is attached to the screen, if you find that there are still bubbles, you can use the BG scratch card to scrape the screen one by one, the air will be discharged. So how to stick the cell phone film?

Step 5: Tear off the ② release film completely.

Step 6: Tear off the ② release film completely, and wipe the screen with a cloth, the entire film process is declared complete.

Points of the film:

1、Paste the film before the screen should be thoroughly clean, especially can not leave dust.

2, ① After tearing off the film, pay special attention to the finger that can not touch the adsorption layer, otherwise affects the film effect.

3, the film process, do not tear the number of release film once, should be torn while pasting.

4, make good use of the scratch card for bubble removal.

About how to stick the cell phone film to answer here, I hope to help you!